INEX 2026

Innovation Catalogue

Gold Medal

AIR-TO-AIR HEAT EXCHANGER OF TURBOMACHINE

Robotics

The development provides an increase in cooling efficiency by 20-40%, depending on the operation mode by changing the design. When using/manufacturing the claimed turbomachine air-to-air heat exchanger, an increase in gas-dynamic efficiency, rigidity and minimization of its own vibrations are achieved, which leads to reliability and durability enhancement of the proposed design as a whole.

Innovator(s)
Marchukov E.Yu., Smirnova E.V., Solovyova A.V.
Organisation
“Lyulka Design Bureau” JSC “UEC-UMPO”
Country
Russia
Exhibition zone
Product Arena
Technology Readiness Level
TRL 5 of 9
Edition
INEX 2026

About this innovation



Fig. 1. Isometric air-to-air heat exchanger


An air-to-air heat exchanger of a turbomachine contains cooled tubular elements 2 installed in the flow part of the bypass duct and rigidly fixed to the stator by means of a connecting device 9. The cooled tubular elements 2 are equipped with heat-removing plates 4 and 5.

Fig. 2. Air-to-air heat exchanger appearance


The innovative geometric shape and arrangement of the heat-removing elements: the cooled tubular elements 2 and the heat-removing plates 4 and 5, as well as the connecting device 9, are made as a single part using additive technologies. The central sections of the cooled tubular elements 2 are made in the form of helical spirals of different diameters.



Fig. 3. Air-to-air heat exchanger length distribution of the  temperature field


The development provides an increase in cooling efficiency by 20-40%, depending on the operation mode by changing the design. When using/manufacturing the claimed turbomachine air-to-air heat exchanger, an increase in gas-dynamic efficiency, rigidity and minimization of its own vibrations are achieved, which leads to reliability and durability enhancement of the proposed design as a whole.

In comparison with analogues, the development has increased reliability and durability of tubular sections, it also eliminates manufacturing defects –  lack of solder penetration in connecting welds, which are likely in a multi-part assembly. It is used in the design of gas turbine engines.